Volkswagen SHARAN - 2008
More faults compared to the average car of same model year
Quick summary
The 2008 Volkswagen Sharan has an overall defect rate of 452 defects per 100 vehicles, which is significantly higher than the yearly average of 337 defects per 100 vehicles, indicating a 34% increase in defects compared to similar models. Notably, this model exhibits particularly high rates of defects in steering and body structure, with the steering defects being 94% higher than average. Additionally, issues related to wheels, suspensions, and axles also stand out, as these are 41% worse than the yearly average. The defect rate increases with mileage, especially in vehicles with over 124,000 miles, where the rate jumps to 586 defects per 100. Overall, while tyre wear is a common concern, the Sharan's specific issues in these categories are more pronounced than those observed in the average vehicle of the same year.
Cars by mileage segment
More model years for Volkswagen SHARAN
Other models from Volkswagen
Categories
- Brake disc or drum: insecure, fractured or otherwise likely to fail
- Brake lining or pad: worn below 1.5mm
- Parking brake efficiency: below minimum requirement
- Flexible brake hose: excessively damaged, deteriorated, chafed, twisted or stretched
- Brake pipe damaged or excessively corroded
- A steering ball joint: with excessive wear or free play
- Steering rack gaiter or ball joint dust cover: missing or no longer prevents the ingress of dirt etc.
- Power steering fluid leaking or system malfunctioning
- Steering rack gaiter or ball joint dust cover: damaged or deteriorated
- A steering ball joint: with excessive wear or free play
- Windscreen or window damaged or seriously discoloured: but not adversely affecting driver’s view
- Obligatory mirror or device: slightly damaged or loose
- Wiper blade: missing or obviously not clearing the windscreen
- Windscreen washers not working or not providing sufficient fluid to clear the windscreen
- Wiper blade: defective
- A rear registration plate lamp or light source missing or inoperative: when rear registration plate has 2 or more lamps or light sources
- A direction indicator: lamp missing, inoperative or in the case of a multiple light source more than 1/2 not functioning
- A headlamp: missing, inoperative or more than ½ not functioning in the case of LED
- Lamp: missing, inoperative or in the case of a multiple light source more than a half not functioning
- Stop lamp(s): all missing or inoperative
- Tyre tread depth not in accordance with the requirements
- A tyre: with a lump, bulge or tear … or with cords exposed or damaged
- A suspension pin, bush, joint or bearing: excessively worn
- A suspension pin, bush, joint or bearing: excessively worn
- A suspension component: excessively damaged or corroded
- Vehicle structure corroded to the extent that: the rigidity of the assembly is significantly reduced
- A transmission shaft constant velocity joint boot: missing, split, insecure or no longer prevents the ingress of dirt
- Exhaust system has a major leak or is insecure
- A transmission shaft constant velocity joint boot: severely deteriorated
- Vehicle structure corroded to the extent that: the rigidity of the assembly is significantly reduced
- Seat belt buckle missing, damaged or not functioning as intended
- is significantly reduced or The strength or continuity of the load bearing structure within 30cm of any seat belt anchorage (a ’prescribed area’): inadequately repaired
- is significantly reduced or The strength or continuity of the load bearing structure within 30cm of any seat belt anchorage (a ’prescribed area’): inadequately repaired
- A seat belt: webbing or flexible stalk significantly stretched or weakened
- An SRS malfunction indicator lamp (MIL) indicates a system malfunction
- Emissions test unable to be completed
- Smoke opacity levels exceed the manufacturer’s specified limit
- Fluid: leaking excessively and likely to harm the environment or to pose a safety risk to other road users
- Engine MIL inoperative or indicating a malfunction
- Emissions test not completed because smoke levels are significantly in excess of the specified limit values