Toyota LAND CRUISER - 2005
365.0 faults per 100 tests
Year average for all cars of 2005 is 377.4 faults per 100 tests
Dataset: MOT tests in Great Britain (period: 2024-01-01 to 2025-09-10) for Toyota LAND CRUISER, model year 2005.
Sample size: 1,184 cars, 2,541 tests and 9,274 recorded faults.
0%
Less faults compared to the average car of same model year
Less faults compared to the average car of same model year
Quick summary
Total: 1,184 cars
The 2005 Toyota Land Cruiser has an overall defect rate of 365 per 100 vehicles, which is slightly better than the average of 376 per 100, representing a 2.8% improvement. While tyre wear is a common concern across vehicles, this model shows significant strengths in steering, visibility, and lights and electrics, with defect rates notably lower than the average in these areas. However, it does exhibit a higher than average rate of defects in body/structure and equipment categories, indicating potential weaknesses in these specific aspects. Mileage-related trends show increasing defect rates with higher mileage, particularly in the 124,000+ miles category.
Cars by mileage segment
Total: 1,184 cars
Categories
Brakes
▲ 6.8% better
147.7 faults / 100 tests
Year avg: 158.5 / 100 tests
- Brake pipe damaged or excessively corroded
- Brake disc or drum: insecure, fractured or otherwise likely to fail
- Brake hose ferrules: excessively corroded
- Brake lining or pad: worn below 1.5mm
- Significant brake effort recorded with no brake applied indicating a binding brake
Steering
▲ 48.2% better
11.6 faults / 100 tests
Year avg: 22.4 / 100 tests
- A steering ball joint: with excessive wear or free play
- Steering rack gaiter or ball joint dust cover: damaged or deteriorated
- Power steering fluid leaking or system malfunctioning
- A steering ball joint: with excessive wear or free play
- Steering rack gaiter or ball joint dust cover: missing or no longer prevents the ingress of dirt etc.
Visibility
▲ 28.9% better
20.2 faults / 100 tests
Year avg: 28.4 / 100 tests
- Wiper blade: missing or obviously not clearing the windscreen
- Wiper blade: defective
- Windscreen or window damaged or seriously discoloured: but not adversely affecting driver’s view
- Windscreen washers not working or not providing sufficient fluid to clear the windscreen
- Obligatory mirror or device: slightly damaged or loose
Lights & Electrics
▲ 22.3% better
85.5 faults / 100 tests
Year avg: 110.1 / 100 tests
- Lamp: missing, inoperative or in the case of a multiple light source more than a half not functioning
- Headlamp reflector or lens: slightly defective
- Beam image obviously incorrect
- A rear registration plate lamp or light source missing or inoperative: when rear registration plate has 2 or more lamps or light sources
- Product on the lens or light source which obviously reduces light intensity or changes emitted colour to other than white or yellow
Wheels & Suspension
▲ 9.8% better
283.3 faults / 100 tests
Year avg: 314.1 / 100 tests
- A suspension pin, bush, joint or bearing: excessively worn
- Tyre tread depth not in accordance with the requirements
- A tyre: with a lump, bulge or tear … or with cords exposed or damaged
- A spring: or spring component fractured or seriously weakened
- A suspension component: excessively damaged or corroded
Body/Structure
▼ 113.0% worse
131.0 faults / 100 tests
Year avg: 61.5 / 100 tests
- Vehicle structure corroded to the extent that: the rigidity of the assembly is significantly reduced
- Exhaust system has a major leak or is insecure
- Body, cab or chassis: excessively corroded at mounting points
- A transmission shaft constant velocity joint boot: severely deteriorated
- Body, cab or chassis: excessively corroded at mounting points
Equipment
▼ 36.4% worse
17.6 faults / 100 tests
Year avg: 12.9 / 100 tests
- A seat belt: webbing or flexible stalk significantly stretched or weakened
- An SRS malfunction indicator lamp (MIL) indicates a system malfunction
- Seat belt not functioning as intended or of an incorrect type
- is significantly reduced or The strength or continuity of the load bearing structure within 30cm of any seat belt anchorage (a ’prescribed area’): inadequately repaired
- is significantly reduced or The strength or continuity of the load bearing structure within 30cm of any seat belt anchorage (a ’prescribed area’): inadequately repaired
Other
▲ 29.6% better
32.9 faults / 100 tests
Year avg: 46.7 / 100 tests
- Fluid: leaking excessively and likely to harm the environment or to pose a safety risk to other road users
- Emissions test unable to be completed
- Emissions test not completed because smoke levels are significantly in excess of the specified limit values
- Smoke opacity levels exceed the manufacturer’s specified limit
- Exhaust emits excessive smoke or vapour of any colour to an extent likely to obscure the vision of other road users
Fault rate by mileage segment
Model
Year average
* Metric: faults per 100 tests.
Most common faults (Top 10)
A suspension pin, bush, joint or bearing: excessively worn
ADVISORY
Occurrences: 731
Brake pipe damaged or excessively corroded
ADVISORY
Occurrences: 630
Vehicle structure corroded to the extent that: the rigidity of the assembly is significantly reduced
ADVISORY
Occurrences: 476
A spring: or spring component fractured or seriously weakened
ADVISORY
Occurrences: 453
Tyre tread depth not in accordance with the requirements
ADVISORY
Occurrences: 383
Fluid: leaking excessively and likely to harm the environment or to pose a safety risk to other road users
ADVISORY
Occurrences: 327
A suspension component: excessively damaged or corroded
ADVISORY
Occurrences: 319
A tyre: with a lump, bulge or tear … or with cords exposed or damaged
ADVISORY
Occurrences: 267
A rear registration plate lamp or light source missing or inoperative: when rear registration plate has 2 or more lamps or light sources
MINOR
Occurrences: 252
Brake lining or pad: worn below 1.5mm
ADVISORY
Occurrences: 251
Serious faults (Top 10)
A suspension pin, bush, joint or bearing: excessively worn
FAIL
Occurrences: 214
The strength or continuity of the load bearing structure within 30cm … is significantly reduced or inadequately repaired
FAIL
Occurrences: 125
Body, cab or chassis: excessively corroded at mounting points
FAIL
Occurrences: 121
A transmission shaft constant velocity joint boot: missing, split, insecure or no longer prevents the ingress of dirt
FAIL
Occurrences: 118
A suspension joint dust cover: missing or no longer prevents the ingress of dirt etc.
FAIL
Occurrences: 106
Vehicle structure corroded to the extent that: the rigidity of the assembly is significantly reduced
FAIL
Occurrences: 97
Lamp: missing, inoperative or in the case of a multiple light source more than a half not functioning
FAIL
Occurrences: 87
Brake pipe damaged or excessively corroded
FAIL
Occurrences: 84
Exhaust system has a major leak or is insecure
FAIL
Occurrences: 65
is significantly reduced or The strength or continuity of the load bearing structure within 30cm of any seat belt anchorage (a ’prescribed area’): inadequately repaired
FAIL
Occurrences: 52